FM-HBA-18 FRANCIS TURBINE (HYDRAULIC BENCH ACCESSORIES) ​

DESCRIPTION

This demonstration turbine provides a simple low cost introduction to the Francis inward flow reaction turbine showing its construction, operation and performance. A tapering, spiral shaped volute conveys water to the runner via a ring of guide vanes that are adjustable in angle to vary the flow through the turbine. Water enters the runner tangentially at the periphery, flows radially inwards through the blades towards the hub then exits axially via a draft tube. Power generated by the turbine is absorbed by a Prony friction brake consisting of a pair of spring balances attached to a brake belt that is wrapped around a pulley wheel driven by the runner. The load on the turbine is varied by tensioning both spring balances which increases the friction on the pulley wheel. Brake force is determined from the difference in the readings on the two spring balances and the torque calculated from the product of this force and the pulley radius. The head of water entering the turbine is indicated on a Bourdon gauge and the speed of rotation is measured using a non-contacting tachometer (not supplied). The volute of the Francis turbine incorporates a transparent front cover for clear visualisation of the runner and guide vanes.


RANGE OF EXPERIMENTS

  • Determining the operating characteristics, i.e. power, efficiency and torque, of a Francis Turbine at various speeds and guide vane opening


UTILITIES REQUIRED

  • Hydraulic Bench


TECHNICAL SPECIFICATIONS

Product Francis Turbine (HBA)
Product Code FM-HBA-18
Speed range 0 to 1000 r.p.m
Diameter of Francis runner 60 mm
Number of blades on runner 12
Number of guide vanes 6, adjustable from fully open to fully closed
Range of spring balances 0 to 10 N x 0.1 N
Range of Bourdon gauge 0 to 2 bar

The whole setup is well designed and arranged in a good quality painted structure.

error: Content is protected !!